Adjusting the Pilot Light on a Range

Remove control knob to access the adjustment screws for the pilot light


Turn adjustment screw until flame tip reaches the center of the flash tub

If range uses a thermocouple, adjust the flame to touch about inch from end of device


If flame is mostly yellow, the flame is not getting enough air. Clean tip of pilot tube.


If you have a split flame, clean out dirt form pilot tube A lifting flowing flame is caused by high gas pressure. Call your utility company.
Sutherlands® provides these project tips and guides as a service to our visitors. Due to possible variance in conditions, equipment, materials and individual skill levels, Sutherlands® assumes no responsibility for losses or injuries incurred during maintenance or repair of your property. Sutherlands® assumes no liability for errors or omissions in the Resources section of this website. Please read and follow any safety precautions provided by tool and equipment manufacturers, and consult a building professional in your area if you have any questions about a repair project. Always check your local codes before building, and obtain the required building permits.